![]() ![]() The cable exhibits proper bned radius at entry and exit of the strain relief clamp device. Ribbon cables should be routed along flat surfaces (either vertical or horizontal) whenever possible, shall be properly supported and secured by cable clamps, and should not be routed near high electrical noise, heat or vibration sources. Inline terminations shall be properly oriented and completed only in locations along the cable designed for such terminations, and where sufficient strain relief is available. The termination exhibits alignment to the connector fiducials (small notches/marks) and grooves. The completed connector assembly shall result in the electrical termination of each conductor to the respective termination pin. Ribbon cable suitable for harness installation shall be of a round-to-flat, transition/breakout type. Ribbon cables shall not be incorporated into discrete wire harnesses, unless specifically designed for that application. The recommended long-term bend radius is ten (10) diameters.Ĭable is properly aligned and oriented in the connector, and the cable end does not protrude in excess of 0.8 mm (0.031 in.) beyond the connector body edge, or violate minimum electrical spacing requirements. The bend radius for coaxial ribbon cables shall not be less than six (6) insulated wire diameters short-term, ten (10) diameters long-term.įlat and ribbon cables shall not be creased, folded or bent less than three (3) insulated wire diameters (short-term). The assembly exhibits a smooth, flat profile, with no visible damage to the connectors or the insulation. Conductors are properly aligned to respective termination pins and properly seated. The cable assembly meets dimensional, layout and design requirements. Ribbon cable is a multi-conductor cable, comprised of individually insulated, stranded conductors, which are mechanically bonded to each other in a parallel (flat) orientation.īoth cable architectures result in a highly flexible, compact and robust cable, allowing mass termination of the conductors to high-density connectors by the insulation displacement contact (IDC) process. ![]() You also have the right to file a complaint to a supervisory data protection authority.CABLE AND HARNESS FLAT/RIBBON CABLE CABLE AND HARNESSįlat cable is a multi-conductor cable comprised of individually insulated, solid conductors, which are mechanically bonded in a parallel (flat) orientation.Withdrawal of consent has no bearing on the legitimacy of processing that was performed prior to the withdrawal. To the extent that your personal data is processed on the grounds of your consent, you have the right to withdraw that consent.You have the right to access your personal data and request it to be corrected, deleted, or limit its processing.Your personal data will be stored until you withdraw your consent to the processing of your personal data.Providing data is voluntary, however, it is necessary to send an information bulletin.Your data will be processed on the basis of point (a) of Article 6(1) of Regulation of the European Parliament and of the Council (EU) 2016/679 of 27 April 2016 on the protection of individuals with regard to the processing of personal data and on the free movement of such data and the repeal of Directive 95/46/EC (hereinafter referred to as: GDPR), in order to send to the provided e-mail address, an electronic news bulletin of TME.The personal data controller has appointed a data protection officer, who can be reached via email.Ustronna 41, 93-350 Łódź hereby informs you that it will be the controller of your personal data. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |